Brita mypure P1 Instructions For Use Manual page 6

B Initial programming of the BRITA Cartridge Status
Indicator:
Depending on the setting you chose for the filter head you will
programm the BRITA Cartridge Status Indicator as follows:
a To reset, push both buttons of the BRITA Cartridge Status Indica-
tor at the same time for three seconds until the colored LED light
flashes green, yellow and red. Make sure you push both buttons
at the same time.
b The button on the left side (HARDNESS) is to choose the water
hardness. Push the button repeatedly until the correct setting for
water hardness appears:
For water hardness setting A the LED flashes once
For water hardness setting B the LED flashes two times
For water hardness setting C the LED flashes three times
(see table below).
c The button on the right side (CARTRIDGE) is to set the cartridge
you are using. Push the button repeatedly until the correct set-
ting for filter cartridge appears:
For filter cartridge P 1000 the LED flashes once
For filter cartridge P 3000 the LED flashes two times
For filter cartridge A 1000 the LED flashes three times
(see table below).
d To change a setting, simply push the button until the right set-
ting is indicated via the corresponding LED.
e Insert the BRITA Cartridge Status Indicator into the appropriate
position of the BRITA Dispenser's lever (see fig. 4).
Mind the right direction of item onset.
(fig. 5)
Water hardness setting (Hardness) A
Cartridge setting (Cartridge)
6
ENGLISH
1. Hardness
2. Cartridge
1x flash 2x flash 3x flash
B C
P 1000 P 3000 A 1000
C How the BRITA Cartridge Status Indicator works
To ensure optimal performance, you should change the filter car-
tridge on a regular basis. The BRITA Cartridge Status Indicator in the
BRITA lever tells you when to change the filter cartridge.
D Signals
The three lights in the BRITA lever are only activated in the filtering
position. They indicate:
– Green light: The BRITA filter is working at optimum performance.
– Yellow light: 90 % of the filter capacity has been used.
Remember to buy a new replacement filter cartridge.
– Red light: The filter cartridge needs to be changed.
E Resetting the BRITA Cartridge Status Indicator
If the maximum volume is reached or the cartridge has been used
for 12 months, the BRITA Cartridge Status Indicator's LED will start
flashing red (only if BRITA lever is in the filtering position).
In this case the filter cartridge should be replaced. Once the car-
tridge has been replaced the BRITA Cartridge Status Indicator has
to be reset.
To reset, remove the BRITA Cartridge Status Indicator from the
lever. Push both buttons of the BRITA Cartridge Status Indicator at
the same time for three seconds until the colored LED light flashes
green, yellow and red. Make sure you push both buttons at the
same time.
Insert the BRITA Cartridge Status Indicator into the appropriate
position of the BRITA Dispenser's lever (see fig. 4). Mind the right
direction of item onset.
F Changing the battery
Battery can be changed without losing prior settings of the BRITA
Cartridge Status Indicator.
Technical data:
• Battery: 1x CR2032 (removable)
• lifetime of battery: app. 2 years
!
Do not immerse BRITA Cartridge Status Indicator in water.