Summary of Contents for Brita PRO PERFORMANCE NRV Series
Page 1
PERFORMANCE SERIES ™ NRV FILTER MANUAL Professional Installation Version V1.0D 54561...
Page 2
NSF/ANSI Standard 44 for material and structural integrity requirements. COMPONENT BRITA ® 828.449.2536 420 3rd Avenue NW www.britapro.com Hickory, NC 28601 BRITA®PRO trademark and logo are registered trademarks of Brita LP and are used under license by Protect Plus, LLC. All rights reserved...
READ THIS PAGE FIRST BEFORE STARTING INSTALLATION COMPONENTS & SPECIFICATIONS SPECIFICATIONS SYSTEM DIMENSIONS INSTALLATION UNPACK & INSTALL PRE-INSTALLATION INSTRUCTIONS ELECTRICAL GROUNDING TOOLS REQUIRED FOR INSTALLATION DETERMINING LOCATION INSTALL BYPASS TO THE FILTER INSTALLATION INSTRUCTIONS OPERATION CARE OF YOUR SYSTEM REPLACING THE MEDIA BED LOADING THE MEDIA PAK PARTS BYPASS PARTS LIST...
See page 6 for unpack and inspect system Do not install this unit where it may be exposed to wet weather, direct sunlight, or temperatures outside of the BRITA PRO reserves the right to change the specifications ® range specified above.
INSTALLATION UNPACK & INSPECT NRV FILTER NRV SYSTEM CONTENTS: • Check the entire unit for any shipping damage or lost parts. • Note any damage to the shipping cartons. 1. Control Valve • Contact the transportation company for all damage and loss claims. 2.
PRE-INSTALLATION INSTRUCTIONS CHECK YOUR WATER HARDNESS Use test strips (Part # 2793828-20) to get an estimation of water hardness. Contact your local BRITA PRO dealer to use a ® BRITA PRO laboratory for a complete water analysis free of cost and no obligation to you.
TOOLS REQUIRED FOR INSTALLATION: Pliers Screwdriver Teflon tape Razor knife Two adjustable wrenches Additional tools may be required if modifications to home plumbing are required. Plastic inlet and outlet fittings are included with the filter. 3/4” or 1” pipes to and from the filter fittings are recommended to maintain full valve flow.
INSTALL BYPASS TO THE FILTER INSTALLATION INSTRUCTIONS If your hot water tank is electric, turn off the power to it to avoid damage to the element in the tank. . If you have a private well, turn the power off to the pump and then shut off the main water shut off valve.
CARE OF YOUR SYSTEM To retain the attractive appearance of your new water filter, clean occasionally with mild soap solution. Do not use abrasive cleaners, ammonia or solvents. Never subject your filter to freezing or to temperatures above 100°F. REPLACING THE MEDIA BED CARBON NRV FILTER - under normal operating conditions the effective life of the filter media is approximately one to three years, depending on the water quality, after which, taste and odor problems may return.
BYPASS PARTS LIST Bypass - 60010002 SYSTEM MINERAL TANK # TANK # TANK # DISTRIBUTOR # VALVE # MEDIA MODEL TANK SIZE (NATURAL (BLACK (BLUE BED # COLOR) COLOR) COLOR) NRV-100 9 x 48 25010034 25010036 25010035 50010005 95402 60010068 NRV-150 10 x 54 25010049...
TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE SOLUTIONS A. FILTER BLEEDS TASTE AND ODOR 1. By-pass valve open. Close by-pass valve. OR SEDIMENT 2. Defective or stripped media bed Replace media 3. Quality of water has worsened Have water sample analyzed to determine any change 4.
Page 13
THIS PAGE INTENTIONALLY THIS PAGE INTENTIONALLY THIS PAGE INTENTIONALLY LEFT BLANK LEFT BLANK LEFT BLANK...
PERFORMANCE DATA STATEMENT This filtration system has been tested and certified according to NSF/ANSI Standard 42 by IAPMO for the reduction of the substances listed below, as verified and substantiated by test data. The concentration of the indicated substances in the water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified in NSF/ANSI Standard 42.
Page 17
PERFORMANCE DATA STATEMENT This filtration system has been tested and certified according to NSF/ANSI Standard 42 by IAPMO for the reduction of the substances listed below, as verified and substantiated by test data. The concentration of the indicated substances in the water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified in NSF/ANSI Standard 42.
Page 18
PERFORMANCE DATA STATEMENT This filtration system has been tested and certified according to NSF/ANSI Standard 42 by IAPMO for the reduction of the substances listed below, as verified and substantiated by test data. The concentration of the indicated substances in the water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified in NSF/ANSI Standard 42.
This limited warranty is solely provided to approved dealers of Brita® Pro Products sold by Protect Plus Pro, LLC and is not applicable to consumers or homeowners. Consumers and homeowners should contact the dealer they purchased their product for warranty information.
Page 20
This limited warranty is solely provided to approved dealers of Brita® Pro Products sold by Protect Plus Pro, LLC and is not applicable to consumers or homeowners. Consumers and homeowners should contact the dealer they purchased their product for warranty information.