Vidicode V-Mic Manual page 15

NOTE: Not all formats can be combined with all Input Source
selections below. The unavailable combinations will be
greyed out.
Recording Input Source
Selects the input source for the recorded audio. This can be the
6.35mm MIC1 jack, or the 3.5mm MIC2 jack, or the built-in
microphone. Switching between mono and stereo is done
automatically. The following selections are available:
MIC1 jack
MIC2 jack
Built-in Mic
MIC1 jack + MIC2 jack
MIC1 jack + Built-in Mic
MIC1 jack with Headset
Phantom Power
Phantom power is a 48 Volt power source on the 6.35mm MIC1 jack.
Enable this option if you have a Phantom enabled microphone.
In combination with automatic level detection, this option needs to
be on always.
Audio on OUT jack
Output the audio from the here selected input to the built-in 3.5mm
jack. When enabled, output will always be on, even if there is no
ongoing recording.
The audio can come from the 6.35mm MIC1 jack, or the 3.5mm MIC2
jack, or a stereo mode from a headset on MIC1 for aviation.
NOTE: The output must be enabled, when automatic recording with
audio detection is done.
Maximum File Size
Split the recording into shorter WAV files. This prevents loss of data
when the power or SD card is suddenly removed. The time per file
(recording-part) can be selected here.
V-Mic Manual EN v1.5 Juli 2020
File Format
Mono
Mono
Mono
Stereo
Stereo
Stereo
© 2020 Vidicode 15