York YK Style H Operation Manual page 113

Table 108: Programmable
V09 software
Button
and earlier
Winding Setup Service
Vibration Gain Admin
Bearing Setup Service
Temperature
Admin
Disable
Table 109: Navigation
V09 software
Button
and earlier
Home Service
Motor Details Service
Model YK Style H Centrifugal Liquid Chillers with OptiView Control Center
V10 and later
with YORK
Description
Chiller Access
Manager
Not shown when Winding Temperature Protection Setpoint on Motor
Details screen is set to Disabled. Allows a Service Technician to program
JCI Service the High Winding Temperature (266°F to 320°F; default 311°F) and
Winding Hotspot Allowance (0°F to 18°F; default 0°F) safety shutdown
thresholds. Values entered are displayed in the respective data boxes.
Only shown when access level is Admin and Motor Vibration Protection
Setpoint on Motor Details screen is not set to Disabled. Allows a Service
Admin
Technician to enter values for vibration Input Gain (1:1, 11:1, 21:1
[default]).
Not shown when Bearing Temperature Protection Setpoint on Motor
Details screen is set to Disabled. Allows a Service Technician to enter
JCI Service
values for High Bearing Temperature Shutdown (149°F to 212°F; default
203°F) and Warning (140°F to 194°F; default 194°F) thresholds.
Only shown when access level is Admin and Winding Temperature
Protection Setpoint on Motor Details screen is not set to Disabled. Allows
a Service Technician to disable individual winding temperature sensors.
Admin The respective temperature data box reflects enabled or disabled status.
This could be applied to defective sensors or for service reasons. When a
sensor is disabled, the respective temperature data box does not appear
on the Motor Details screen.
V10 and later
with YORK
Description
Chiller Access
Manager
JCI Service Returns the user to Home screen.
JCI Service Returns the user to Motor Details screen.
113