York YK Style H Operation Manual page 103

Table 99: Programmable
V09 software
Button
and earlier
Motor Lube
Admin
Date
Start Auto Lube Service
Motor Lube
Operator
Acknowledge
Table 100: Navigation
V09 software
Button
and earlier
Home View
Motor View
Model YK Style H Centrifugal Liquid Chillers with OptiView Control Center
V10 and later
with YORK
Description
Chiller Access
Manager
Admin Allows modification of the Date of Last Motor Lubrication.
This button is only displayed when automatic lubrication hardware is
installed and the setpoint is set in the Setup Screen. When the Auto-
JCI Service Lube is enabled, no lubrication warnings or safety shutdowns will occur.
Pressing this button starts the auto-lube procedure for the P203 lube
system.
When the motor lubrication has been performed, the Operator must
acknowledge the lubrication has been performed. This is done by
entering his/her initials, name or user ID as a 3 to 8 character string. The
entry is displayed as the Operator Initials at Last Lubrication. The date
and time of this entry is automatically logged as the Date of Last Motor
Lubrication and Time of Last Motor Lubrication. This entry also resets the
operating hours since last lubrication to zero.
This entry also resets the motor lubrication warning messages WARNING
– MOTOR BEARING LUBE SUGGESTED, WARNING – MOTOR BEARING
LUBE REQUIRED, and the safety shutdown message Motor – Lack Of
Bearing Lubrication.
Enter your initials, name or user ID using the following procedure. The
entry must be a minimum of 3 characters and a maximum of 8 characters.
• At the keypad, log in at Operator access level using password 9 6
7 5. If resetting the safety shutdown Motor – Lack Of Lubrication,
place Compressor Switch in Stop-Reset (O) position.
Standard
• Press the Motor Lube Acknowledge key on the Motor Lubrication
Screen. A dialog box appears. A red box highlights the first
changeable location.
• Use the ▲▼ keys to scroll sequentially through the alphabet to
enter letters or numbers. Each time the ▲ is pressed, the next
higher sequential alphabet letter or number is displayed. Each
time the ▼ is pressed, the next lower alphabet letter or number is
displayed. When the desired letter or number is displayed, use the
► key to forward space the red box for the next entry. Use the ◄
key to backspace, if necessary. To write over an existing entry or
to place a blank space, scroll to the beginning of the alphabet. The
selection prior to the letter A is a blank space. Use the ● key to enter
a period/decimal point. During the entry process, if it is desired to
exit the dialog box and retain the previous entry, press the Cancel
(X) key.
• When all of the required characters have been entered, press the
Enter key.
V10 and later
with YORK
Description
Chiller Access
Manager
View Returns the user to Home screen.
View Returns the user to Motor screen.
103