Ports And Dip Switches; Introduction; Front Bezel Port (All Models); Figure 4-1 Front Bezel Led Control Port (All Models) - FutureLogic PSA-66-ST2 Technician Manual

4 Ports and Dip Switches

Introduction

This chapter describes the interface connectors and port pin-outs for each model of the
printer. For complete electrical specifications on these ports, refer to Appendix A in the
Developers Manual (MNL-000004) for the power connector.
There are two models of the PSA-66-ST2 printer:
•
PSA-66-ST2N. Netplex Interface. See page 12.
•
PSA-66-ST2R. RS232 Interface. See page 16.
Note: While PSA-66-ST2 refers to both the PSA-66-ST2R and PSA-66-ST2N versions of the
printer, this manual is written primarily for the RS232 interface. For additional
information on the Netplex interface, please contact International Game
Technology.

Front Bezel Port (All Models)

Figure 4-1 Front Bezel LED Control Port (All Models)
Table 4-1 lists information on the LED bezel port on the GEN2 printer. This is an open drain
modulated high side drive 25VDC port capable of driving up to a maximum 1.5A.
Table 4-1
© 2002 – 2007 FutureLogic, Incorporated. All Rights Reserved.
Front Bezel LED Control Port Pins (All Models)
Pin Function
1 Switched 25VDC, 100mA Min
2 BGND
3 Frame (Chassis) Ground
Operators and Technicians Manual
Bezel LED Control Port
3
Connector: Molex Micro-Fit 43640-0301
Mate: Molex Micro-Fit 43645-0300
MNL Page 11 of 52 12/07/2007
2 1
MNL-000003 REV.N