Table 4-8 Psa-66-St Rs232 10 Position Dip Switch Settings - FutureLogic PSA-66-001N Operator's Manual

Figure 4-7
Table 4-7
POS FUNCTION
1 Reserved
2
3
4
5
6
7 INTERFACE SELECT
!Note: this must be set
for future compatibility
8 COMMUNICATIONS
9 PROTOCOL
10 HANDSHAKING
UM-STO-C Revision C
The printer has a set of 10 dip switches which appear through an
access slot on the bottom of the stationary module. The dip switches
are used to select the communications protocol. The switches must
be set according to the table below.
Be sure to set dip switch 7 properly in order to maintain
future compatibility between machines.
1
PSA-66-ST RS232 Dip Switches Bottom View
PSA-66-ST RS232 10 Position Dip Switch Settings
OFF
off
OFF
ON
9=OFF 8=OFF
9=OFF 8=ON
9=ON 8=OFF
9=ON 8=ON
OFF
ON
Operators and Technicians
Manual
PSA-66-001N
PSA-66-ST
PSA-66-ST
RS232 Version
10
CONFIGURATION
these switches must always be left
Not allowed
RS232
illegal setting, do not use
serial 38400,N,8,1
serial 9600,N,8,1
serial 57600,N,8,1
XON/XOFF + RTS hardware handshake
RTS hardware handshake only
25