Brother MFC-6650MC Owner's Manual page 217

DIFFICULTY
DOS Setup
I cannot print from my
Printing
application software
Difficulties
The MFC prints, but it
prints incorrect
information. Sometimes
it prints a couple of
character and then ejects
the pages, etc.
The MFC prints the first
part of my document but
does not print the last page correctly set up. The data has been sent to the printer
(The LCD shows
REMAINED DATA)
How can I change the
user settings or default
settings on the MFC?
Paper
The MFC does not load
Handling
paper. The LCD shows
Difficulties
CHECK PAPER or
PRINTER JAM
The MFC does not load
paper from the manual
feed slot.
How can I load envelopes? You can load envelopes from either the multi-purpose
What paper can I use?
How can I clear paper jams?
T R O U B L E S H O O T I N G A N D M A I N T E N A N C E
SUGGESTIONS
Check that the DOS application software interface
settings match those of your printer: for example, if
you are using a parallel printer cable, you would
probably set your DOS software printer port to
LPT1. Check for an error message on the LCD.
This is an indication that your application printer
emulation Prints setting and the MFC'S printer
emulation do not match. Check your application
software to make sure you selected the correct printer
driver. The MFC emulates HP LaserJet IIP.
Try setting the MFC to HP emulation in Remote
Printer Console and then select the HP LaserJet IIP
printer in your application software.
This is common problem with database software and
Part of spreadsheet software when they are not
but the printer did not receive the Page Eject command.
Press FF/Cont to eject the page. Then ask
your software supplier how to add a Page Eject (or
Form Feed) command to the end of your print job.
Use the Remote Printer Consol (RPC) program.
Check to see if the CHECK PAPER or PRINTER JAM
message appears on the LCD. If so, the multi-purpose
sheet feeder may be out of paper or not properly
installed. If it is empty, load a new stack of paper into the
feeder. If there is paper in the multi-purpose sheet feeder,
make sure it is straight. If the paper is curled, you should
straighten it. Sometimes it is helpful to remove the
paper, turn the stack over and put it back into the multi-
purpose sheet feeder. Reduce the amount of paper in the
multi-purpose sheet feeder, then try again.
Reinsert the paper firmly, one sheet at a time.
sheet feeder or the manual feed slot. Your application
software must be set up to print the envelope size you are
using. This is usually done in the Page Setup or
Document Setup menu of your software. Refer to your
application manual.
You can use plain paper, envelopes, transparencies, labels
and organizer paper. For information on paper you can
use, see "Acceptable Paper" on page 18.
See "Printer Jams" on page 197.
203