56
C H A P T E R S I X
Dual Access
You can scan up to 50 documents into the fax memory, even while the MFC
is receiving or sending another fax (from memory). You can set temporary
settings for each fax you're scanning, except Timer and Polling.
If you try to scan in and store a 51st fax, the MFC will send it immediately,
without storing it in memory.
If you get a MEMORY FULL message while scanning the first page of a
fax, press
to cancel scanning. If you get a MEMORY FULL message
Stop
while scanning in a subsequent page, you'll have the option to press
transmit the pages scanned so far, or to press
Make sure the document feeder is empty.
1
Place the document in the feeder.
2
Enter the fax number.
3
4
Press
. The MFC starts scanning the document and the screen
Start
displays the job number (#XX) of the fax and how much memory is
available. Then the MFC starts dialing. You can immediately repeat
steps 1 through 4 for the next fax.
Your MFC normally operates in Dual Access mode. However, you can
override Dual Access by using Real Time Transmission.
Real Time Transmission
When Memory is full, the MFC cannot continue to scan documents into
memory before sending. However, you can turn on REAL TIME TX; place
the documents in the feeder and enter the fax number. As soon as the phone
line is free, the MFC starts dialing and sending the fax.
1
Place the document in the feeder.
2
Press
Function
,
1
,
The screen displays
9.REAL TIME TX
Press
.
3
Set
Stop
,
.
3
9
Start
to cancel the operation.
to