Remote Retrieval; Using Remote Access Code - Brother MFC-6650MC Owner's Manual

104
C H A P T E R T W E L V E

Remote Retrieval

This section is for the MFC 6650MC only. (If you have the MFC 4350,
MFC 4650 or MFC 7750, please see Chapter 9 for your remote fax options.)
You can call your MFC from any fax machine using touch tone. Use a
Remote Access Code and other button presses to retrieve voice (and fax)
messages. You can also program and change some settings for your Message
Center. Keep the included Remote Control Access Card in your wallet as an
aid.

Using Remote Access Code

To listen to your voice messages, you can call from any touch tone phone.
To receive faxes at your location, you must call from a fax machine using
touch tone. For convenience, you can retrieve faxes from a touch tone phone
by having them sent to a fax machine. For example, if your hotel room does
not have a fax machine, you can enter the number of the fax machine at the
hotel's Front Desk.
1
Dial your MFC phone number.
2
When your MFC answers and beeps, immediately enter your Remote Access
Code.
3
The MFC signals the kinds of messages received:
1 long beep—Fax message(s)
2 long beeps—Voice message(s)
3 long beeps—Fax and Voice message(s)
No beeps—No messages
4
The MFC then prompts you with two short beeps to enter a command.
If you wait longer than 30 seconds to enter a command, the MFC hangs
up. If you enter an invalid command, the MFC beeps three times.
5
Press to reset the MFC when you finish.
9 0
6 Hang up.
If your MFC is set to MANUAL mode, you can access the Message Center by
waiting about 2 minutes, then entering the Remote Access Code within 30
seconds.