Safety; Instruction Manual; Instructions For Start-Up; General Safety Instructions - INOXPA NL Installation, Service And Maintenance Instructions

1.1. INSTRUCTION MANUAL.

This instruction manual contains basic indications which should be fulfilled during the installation, starting and maintenance.
The information published in the instruction manual is based on updated information.
INOXPA reserves the right to modify this instruction manual without prior notice.

1.2. INSTRUCTIONS FOR START-UP.

This instruction manual contains vital and useful information to appropriately handle and maintain your valve.
Not only should the safety instructions indicated in this chapter be observed and fulfilled, but so should the special measures
and recommendations included in the other chapters of this manual. These instructions should be kept in a safe location near
the installation.

1.3. SAFETY.

1.3.1. Warning symbols.
Danger for persons in general
Electric danger
Danger! Suspended loads
Commitment to safety at the workplace.

1.4. GENERAL SAFETY INSTRUCTIONS.

Read the instruction manual carefully before installing and starting up the valve. Contact INOXPA in
case of doubt.
1.4.1. During the installation.
Technical Specifications
The
The installation and use of the valve/actuator should always be carried out in accordance with
applicable regulations regarding health and safety.
Before starting up the valve/actuator, verify that the assembly is correct and that the shaft is
perfectly aligned. An incorrect alignment and/or excessive force in securing the valve/actuator may
cause serious mechanical problems in the valve/actuator.
During the installation, all the electric work should be carried out by authorised personnel.
1.4.2. During operation.
Technical Specifications
The
limit values specified be exceeded.
ED. 2009/11
1. Safety
of Chapter 8 should always be observed.
of Chapter 8 should always be observed. Under no circumstances can the
Safety
www.sks-online.com
www.sks-webshop.com
Danger of injury caused by rotating
equipment parts.
Danger! Caustic or corrosive agents.
Danger for the correct operation of the
equipment.
Protective goggles requirement.
3