Brother MFC-5490CN User Manual page 134

Error Message Cause
The machine is out of paper, paper
No Paper Fed
is not correctly loaded in the paper
tray.
The Jam Clear Cover is not closed
correctly.
The paper is jammed in the
machine.
No Response/Busy The number you dialled does not
answer or is busy.
You tried to access a One Touch or
Not Registered
Speed Dial number that is not
programmed.
The machine's memory is full.
Out of Memory
The memory card or USB Flash
memory drive you are using does
not have enough free space to scan
the documents.
Paper is jammed in the machine.
Paper Jam
Print Unable XX The machine has a mechanical
problem.
—
OR
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
Scan Unable XX
problem.
—
OR
A foreign object such as a clip or
ripped paper is in the machine.
124
—
—
Action
Do one of the following:
Refill the paper in the paper tray, and then
press Mono Start or Colour Start.
Remove the paper and load it again and then
press Mono Start or Colour Start (See
Loading paper and other print media
on page 8.)
Check that the Jam Clear Cover is closed evenly
at both ends. (See Printer jam or paper jam
on page 127.)
See Printer jam or paper jam on page 127.
Verify the number and try again.
Set up the One Touch or Speed Dial number.
(See Storing One Touch Dial numbers
on page 54 or Storing Speed Dial numbers
on page 55.)
Fax sending or copy operation in progress
Press Stop/Exit and wait until the other
operations in progress finish and then try again.
Delete unused files from your memory card or
USB Flash memory drive to make some free
space and then try again.
Remove the jammed paper by following the steps
in Printer jam or paper jam on page 127.
Make sure the paper length guide fits to the paper
size.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 125 before disconnecting
the machine so you will not lose any important
messages.
Then, disconnect the machine from the power for
several minutes, then reconnect it.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 125 before disconnecting
the machine so you will not lose any important
messages.
Then, disconnect the machine from the power for
several minutes, then reconnect it.