ABB ACS 160 User Manual page 119

Alarm
Name
Code
25
26 **
OUTPUT OVERLOAD
27 *
AUTOMATIC RESET
28 *
PID SLEEP
29
30
31
BR RES OVERLOAD
Note! Alarms (*) will not cause relay output RO1 (RO2) to activate when the relay output is
configured to indicate alarm condition in general. (Parameter 1401
2) has value 5 (
RELAY OUTPUT
Note! Alarms (**) will be shown only if parameter 1608
ACS 160 User's Manual
Description
Reserved.
Inverter overload condition. The ACS 160 output current exceeds the ratings
given in Reference Section P.
ACS 160 is about to perform automatic fault reset operation. As a result, the
drive may start after the reset operation. Refer to parameter group 31
AUTOMATIC RESET.
PID sleep function is active. The drive may accelerate when PID sleep function
is deactivated. Refer to parameters 4018
, 4014
DELAY PID SLEEP LEVEL
Reserved.
Reserved.
Brake resistor is nearly overloaded. Refer to brake resistor instructions.
) or 13 ( /
ALARM FLT ALARM
SLEEP SELECTION
and 4015 -
WAKE UP LEVEL
RELAY OUTPUT
)).
is set to 1 (
DISPLAY ALARMS
, 4013
PID SLEEP
.
1 (1402
)
YES
109