Configuration - Welch Allyn CP 20 User Manual

CP 20_______________________________________________________________________Section 3
Configuration Page 1
Software Version
The displayed number identifies the firmware version of your electrocardiograph.
Cart Number
Cart numbers indicate which electrocardiograph transmitted a particular ECG.
Site Number
This option identifies the site of your CP 20. Site numbers designate the hospital, clinic, or institution for ECG
records stored in Welch Allyn CardioPerfect workstation and must be defined for transmitting ECGs. You can use
up to four digits for the site number, numbers from 0 –9999 are supported.
Site Name
This option defines your clinic, hospital, or office name. You can enter up to 30 alphanumeric characters. The site
name prints at the bottom, left edge of the ECG printout.
Telephone Number
This option specifies the telephone number for the ECG transmission to the CardioPerfect workstation. Enter up to
30 alphanumeric characters, and use the BACKSPACE
To wait for an additional dial tone, use the letter W. For example, you may need to dial a 9 to get an outside line.
EXAMPLE: 9W14145554321
To insert a pause use a comma (,).
To change tone dialing to pulse dialing, use the letter P.
EXAMPLE: P14145554321
(If necessary, you can use both the letter W and the letter P in the same phone number.)
NOTE: only enter a phone number if you will be transferring ECGs by modem, otherwise leave this option
blank.
key to erase entry errors.
3-6