Table of Contents
Advertisement
© Panduit Corp. 2020
3: GENERAL POWER TOOL SAFETY WARNINGS
The PLA System is electrically operated and electronically controlled. Therefore, certain safety practices
must be followed.
•
•
•
3A: Work Area Safety
1
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
2
DO NOT OPERATE ELECTRONIC TOOLS IN EXPLOSIVE ATMOSPHERES, SUCH AS
IN THE PRESENCE OF FLAMMABLE LIQUIDS, GASES OR DUST. Powered tools create
sparks which may ignite the dust or fumes. Provide adequate ventilation around the product.
3
KEEP CHILDREN AND BYSTANDERS AWAY WHILE OPERATING A POWERED
TOOL. Distractions can cause you to lose control.
3B: Electrical Safety
1.
Power tool plugs must match the outlet. Never modify the plug in any way. Do not
use any adapter plugs with earthed (grounded) stationary tools. Unmodified plugs
and matching outlets will reduce risk of electric shock.
2.
Avoid body contact with earthed or grounded surfaces, such as pipes, radiators,
ranges and refrigerators. There is an increased risk of electric shock if your body is
earthed or grounded.
3.
DO NOT EXPOSE POWER TOOLS TO RAIN OR WET CONDITIONS. Water entering a
stationary tool will increase the risk of electric shock.
4.
DO NOT abuse the cord. Never use the cord for carrying, pulling, or unplugging the
stationary tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
5.
When operating a stationary tool outdoors, use an extension cord suitable for
outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
6.
If operating a stationary tool in a damp location is unavoidable, use a residual
current device (RCD) protected supply. Use of an RCD reduces the risk of electric
shock. NOTE: The term "residual current device (RCD)" may be replaced by the term
"ground fault circuit interrupter (GFCI)" or "earth leakage circuit breaker (ELCB)".
7.
Only operate the Panduit Label Applicator System in a clean, dry, indoor
environment
8.
This unit includes a protective earthing design and has been testing per IEC 60601-1.
Rev. 02
PLA-100, PLA-H100
WARNING
Read all safety warning and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire, and/or serious injury.
Save all warnings and instructions for future reference.
The term "stationary tool" in the warnings refers to your main-operated (corded)
electronic tool or battery-operated (cordless) stationary tool.
Page 8 of 34
1 / 2021
Advertisement
Table of Contents
Troubleshooting
