Take-Up Error Troubleshooting - Panduit PLA-100 Operation Manual

© Panduit Corp. 2020
Peel and Present Error LED
Double Flash (**_**_**_**)
Cadence 2
Note: "Cadence" refers to the flashing pattern of the Peel and Present Error LED.
Note: During normal operation, if label does not get wrapped after the cable detection switches
are engaged and is still presented at the wedge, the HMI will blink the Cadence 1 on the Peel
and Present LED and remain in ready State.
12C: Take-Up Error Troubleshooting
Error Location Indicator and State
Take-Up Error LED
On (steady)
Rev. 02
PLA-100, PLA-H100
Label is still presented, at the
peel plate, and a cable has
been inserted into the
Applicator Head.
Media failed to find Home and
label did not peel.
Media is slipping on Take-up
spindle.
Potential Problem
Take-Up motor failed to
initialize. Take-Up spool
overloaded. Only during
power-up and initialization.
Take-Up chattering or not
peeling labels due to maximum
diameter reached 5.00" .
Page 25 of 34
Contact the cable to the label, more
slowly, to ensure adhesion and label
removal, prior to attempting a wrap.
Re-align media, within roller guides.
Remove take-up hub and reattach
liner/tether to take-up spindle (see
section 10. Installing the Media).
Solution
Contact Panduit Service Center.
Remove Take-Up and attach new
tether and press the reset button to
clear error.
1 / 2021