Service And Warranty; 4: Safety Practices Addendum; General Safety Practices; Electrical Safety Practices - Panduit PLA-100 Operation Manual

© Panduit Corp. 2020
3E: Service and Warranty
1. Product Registration and Warranty (Visit www.panduit.com)
•
Path: Support/Product Registration
•
Path: Support/Download Center/Limited Product Warranty
2. For Service: Have the tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the tool is maintained.
Contact Panduit Electrical Products Division at the following locations:
Panduit Electrical Products Division (USA)
16530 W. 163 Street
rd
Lockport, IL 60441
1-800-777-3300

4: SAFETY PRACTICES ADDENDUM

4A: General Safety Practices
1. Panduit Corp. recommends the tool be used with all installed safety features.
Customer assumes all liability for injury that could result from improper use of this
tool and responsibility for all necessary training to ensure safe operation of this
tool.
2. To prevent unintentional injury, DO NOT place the Panduit Label Applicator System
where a ladder is required for access.
•
For installation and use by trained personnel only
•
If any damage to the product is apparent or suspected, do not use the product. refer
product to qualified service personnel
•
FCC Warning: changes or modifications to the product could void the user's authority to
operate the product
4B: Electrical Safety Practices
NOTE: KEEP AWAY FROM LIVE CIRCUITS
1. Operating personnel must use caution when opening cover
2. Replacement of components and internal adjustments must be made by qualified
maintenance personnel
3. Disconnect power cable when replacing components
4. Dangerous voltages may exist even with the power cable removed
5. To avoid injuries, always disconnect power and discharge circuits by grounding before
touching circuitry
6. Input connection to the product must remain accessible as a disconnect device
7. DO NOT work on the product; connect or disconnect cables during periods of lightning
8. Provide wiring per national and local electrical codes
4C: Operational Safety Practices
1. DO NOT attempt to operate with cover open.
Rev. 02
PLA-100, PLA-H100
Panduit EMEA Service Center (EUR)
EMEA Tool Service Center
Bedrijvenpark Twente 360
7602 KL Almelo
tel + 31 546 580 451
Page 10 of 34
1 / 2021