Applicator Head Error Troubleshooting; Peel And Present Error Troubleshooting - Panduit PLA-100 Operation Manual

© Panduit Corp. 2020
12A: Applicator Head Error Troubleshooting
Error Location Indicator and State
Applicator Head Error LED
On (steady)
12B: Peel and Present Error Troubleshooting
Error Location Indicator and State
Peel and Present Error LED
On (steady)
Peel and Present Error LED
Single Flash (*_*_*_*) Cadence 1
Rev. 02
PLA-100, PLA-H100
Potential Problem
Wrapper mechanism failed to
home. Label wrap cycle
incomplete or jammed.
Incompatible Cable Size.
Label or debris caught in the
wrapper head.
No communication with
applicator head
Using direct lighting at less
than 36 inches of the wrapping
area may affect sensor
performance.
Applicator head mechanism at
end of life > 500K Cycles.
Potential Problem
Label failed to home. Label
homing incomplete.
Using direct lighting at less
than 36 inches of the wrapping
area may affect sensor
performance.
Label presented past
designated system stop.
Multiple feeding of labels.
Label does not peel due to
improper media installation.
Leading edge of label catches,
preventing it from fully feeding.
Page 24 of 34
Solution
Reset button will be illuminated along
with the error location. Press the reset
button to re-home the wrapper
mechanism.
Check cable diameter to ensure that it
is measured between 0.120" - 0.480".
Detach the applicator head from the
dispenser baseplate by removing the 2
thumb screws. Detach the applicator
head cable from the wrapper head.
From the bottom of the assembly,
remove the debris from the
mechanism. Re-attach. Press the
reset button to re-home the wrapper
mechanism.
Check attachment of the applicator
head cable from the applicator head.
Please refrain from direct lighting to
the side of the system. Contact
Panduit Service Center if issues
persist.
Replace wrapper core. Contact
Panduit Service Center.
Solution
Press the reset button to re-home the
label.
Take-up roll may be too large. Power
down, remove take-up material, re-
install material, and power up.
Please refrain from direct lighting to
the side of the system. Contact
Panduit Service Center if issues
persist.
Check media to determine if the slot is
cleared.
Confirm whether the media is installed
in the proper orientation, with label
facing down, liner routed through the
proper path, and printed portion on the
leading side of the label.
Replace static Brushes on applicator
head. Contact Panduit Service Center.
1 / 2021