Network Settings - Panduit PLA-100 Operation Manual

PLA-100, PLA-H100
© Panduit Corp. 2020
"Change" button immediately to the right. The Device Name can be restored to the
factory default value as described in Restore section on Page 32.
13E: Network Settings
The Network Settings shows the current method the PLA SYSTEM uses to obtain
an IP Address on the network, the current IP Address, the Network Mask and
Gateway address values. In the default DHCP setting, the PLA SYSTEM will
connect to the network and look for a DHCP server to issue an IP Address. The IP
Address Mode can be changed to Static by clicking on the "Change" button
immediately to the right.
When the IP Address Mode is changed, an IP Address, an optional Network Subnet
Mask and optional Gateway address can also be entered. The IP Address Mode
can be restored to the factory default value as described in Restore section on Page
32.
1 / 2021
Rev. 02
Page 30 of 34