© Panduit Corp. 2020
12D: Media Detect Error Troubleshooting
Error Location Indicator and State
Media Detect Error LED
On (steady)
Media Detect Error LED
On (Flashing)
12E: Media Error Troubleshooting
Error Location Indicator and State
Media Error LED
On (steady)
12F: Non- Indicated Errors/Failures Troubleshooting
Problem: Incomplete wrap/installation. Label does not adhere to cable during wrap process
Solution: Check for Label/Cable contamination
Problem: Incomplete wrap/installation. Label does not adhere to cable during wrap process
Solution: Use consistent application pressure between cable and label on both cable guides
Problem: Incomplete wrap/installation. Loose or telescoping wrap. Label does not adhere to
cable during wrap process.
Solution: Use wire straightener remove wire set prior to label application
Problem: Label stubs preventing it from fully feeding.
Rev. 02
PLA-100, PLA-H100
Potential Problem
Incompatible Media.
Media installed incorrectly;
Label facing up.
Media Detection system is
obstructed.
System does not operate, and
Media Detect Error LED is on.
Media Detection Malfunction;
50 consecutive cycles without
Panduit media recognition
Potential Problem
Incorrect Media selected or
loaded in the applicator.
Page 26 of 34
Solution
Use appropriate Panduit label media
Remove spool from unwind spindle,
flip the spool over, and re-install the
media.
Ensure Media Detect system camera
is unobstructed. Power cycle unit.
Contact Panduit Service Center.
Power cycle unit. If this persist,
Contact Panduit Service Center.
Solution
Replace or select correct media with
selector. See figure 14C.
1 / 2021