Introduction; Scope Of The Document; At Command Syntax - Quectel BC26 Manual

1

Introduction

1.1. Scope of the Document

This document gives details of the AT Command Set supported by Quectel NB-IoT BC26 module.

1.2. AT Command Syntax

The "AT" or "at" prefix must be set at the beginning of each command line. To terminate a command line
enter <CR>. Commands
"<CR><LF><response><CR><LF>". Throughout this document, only the responses are presented,
"<CR><LF>" are omitted intentionally.
The AT Commands Set implemented by BC26 is a combination of 3GPP TS 27.005, 3GPP TS 27.007
and ITU-T recommendation V.250 as well as the AT Commands developed by Quectel.
All these AT commands can be split into three categories syntactically: "basic", "S parameter", and
"extended". They are listed as follows:

Basic syntax
These AT commands have the format of "AT<x><n>", or "AT&<x><n>", where "<x>" is the command, and
"<n>" is/are the argument(s) for that command. An example of this is "ATE<n>", which tells the DCE
whether received characters should be echoed back to the DTE according to the value of "<n>". "<n>" is
optional and a default will be used if it is missing.

S parameter syntax
These AT commands have the format of "ATS<n>=<m>", where "<n>" is the index of the S register to set,
and "<m>" is the value to assign to it. "<m>" is optional; if it is missing, then a default value is assigned.

Extended syntax
These commands can be operated in several modes, as following table:
BC26_AT_Commands_Manual
are usually followed
NB-IoT Module Series
BC26 AT Commands Manual
by a response that includes
7 / 73