Quectel BC26 Manual page 60

Test Command
AT+QENGINFO=?
Parameter
<mode> Integer value indicating requested engineering information.
0 display Radio information for serving and neighbor cells
1 display data transfer information only if modem in RRC-CONNECTED state
<sc_earfcn> Integer value indicating the EARFCN for serving cell. Range 0-262143
<sc_earfcn_offset> Integer value indicating the EARFCN offset for serving cell:
0
1
2
3
4
Integer value indicating the serving cell physical cell ID. Range 0 – 503.
<sc_pci>
<sc_cellid> String type; four byte (28 bit) cell ID in hexadecimal format for serving cell.
<sc_rsrp> Signed integer indicating serving cell RSRP value in units of dBm (can be negative
value). Available only in RRC-IDLE state.
<sc_rsrq> Signed integer indicating serving cell RSRQ value in units of dB (can be negative
value). Available only in RRC-IDLE state.
<sc_rssi> Signed integer indicating serving cell RSSI value in units of dBm (can be negative
value). Available only in RRC-IDLE state.
<sc_snr> Signed integer value. Last SNR value for serving cell in units of dB.
Available only in RRC-IDLE state.
BC26_AT_Commands_Manual
OK
When <mode>=1:
Response
+QENGINFODT:
<RLC_UL_BLER>,<RLC_DL_BLER>,<MAC_UL_BLER>,<
MAC_DL_BLER>,<MAC_UL_total_bytes>,<MAC_DL_total
_bytes>,<MAC_UL_total_HARQ_TX>,<MAC_DL_total_HA
RQ_TX>,<MAC_UL_HARQ_re_TX>,<MAC_DL_HARQ_re_
TX>,<RLC_UL_tput>,<RLC_DL_tput>,<MAC_UL_tput>,<
MAC_DL_tput>
OK
If there is any error, response:
ERROR
Response
+QENGINFO=(list of supported <mode>s)
OK
Offset of -2
Offset of -1
Offset of -0.5
Offset of 0
Offset of 1
NB-IoT Module Series
BC26 AT Commands Manual
60 / 73