Advantech PCLD-8811 Startup Manual

PCLD-8811
Low-Pass Active Filter Board
Packing List
Before installation, please make sure that you have:
• 1 x Filter Board
• 2 x Screws
• 1 x Pair of Tweezers
If anything is missing or damaged, contact your
distributor or sales representative immediately.
Features
• The low-pass active filter has the flattest frequency
response as possible in the passband
• 8 set of low-pass Frequencies form 10Hz up to 40KHz
• 2 single-ended or 1 differential AI inputs
• Offset and gain calibration
General Specifications
General
• Connectors 2 x 5 pin male Connectors
• Dimensions 80 x 56 mm
• Filter Type Active Filter - Butterworth
• Offset Error ± 1 LSB ( LSB resolution refer to
taken DAQ spec. )
• Gain Error ± 1 LSB ( LSB resolution refer to
taken DAQ spec. )
• Filter Frequency -3dB,10Hz, 50Hz,100Hz, 500Hz
1KHz, 5KHz, 10KHz,40KHz
• Max. Input Voltage ± 10 V
• Input Impedance 1G Ω / 2pF
• Operating Temp. 0 ~ 60°C (32 ~ 140°F)
• Storage Temp -20~ 70°C (-4 ~ 158°F)
Notes
For more information on this and other Advantech
products, please visit our websites at:
http://www.advantech.com
For technical support and service:
http://www.advantech.com/support/
This startup manual is for PCL-8811.
Part No: 2003881100
1 Startup Manual
Getting Started
Before you can use the PCLD-8811, you must enable
filter function on PCLD-8810 (please refer to PCLD-
8810 Startup manual) and you can refer to the below
table to set up the cut-off frequency.
Diagram
1. Plug the PCLD-8811 onto the PCLD-8810
2. Screw the pillars to the cylinders.
Note: Ensure that the pillar is aligned to the cylinder.
1st Edition
May 2015