Assembly And Installation; Operation - Power Fist 8885642 Manual

V1.0
IDENTIFICATION KEY
A Handle
B Bolt
C Tightening Screw Cap
D Adapter
E Pins
F Disc Pad Spreader
G Wind-Back Tool
H Adapter Plates
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
1. Pull the handle (A) fully to one side.
2. Maneuver the disc pad spreader's (F) opening over the handle and
move the spreader to the bolt (B).
3. Maneuver the spreader over the bolt and slide it down to rest on the
tightening screw cap's (C) raised lip.
4. Select the appropriate adapter plate (H) (see Appendix A).
5 Align the wind-back tool's pins (E) with the adapter plate holes and
affix the plate to the tool.

OPERATION

Consult the vehicle owner's manual or the parts service manual for
instructions on installation and maintenance of the brake caliper system.
1. Align the adapter plate's pins with the openings on the vehicle's caliper
piston and seat the plate.
2. Slide the disk pad spreader back until it rests against the caliper's
forks. Rotate the tightening screw cap clockwise by hand to secure the
spreader so it does not slip. Finish tightening with a wrench.
3. Open the brake's bleeder screw enough to let trapped air escape.
4. Turn the handle clockwise to force the piston to rotate inward.
Continue to apply pressure until the piston no longer moves. Visually
confirm it is seated and not jammed. A jammed piston may require
replacement.
5. Close the brake's bleeder screw.
Visit www.princessauto.com for more information
Brake Caliper Wind-Back Tool Kit 8885642
Fig. 1
5