Modular I/O Card - Brother HL-2400Ce Series User Manual

Modular I/O Card

Before installing an NC-2010h/2100h Network card, please note the
following information.
Before NC-2010h/2100h Installation
(USA)
When you install the NC-2010h/2100h Ethernet interface card, this printer
complies with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules.
Please refer to the NC-2010h/2100h User's Guide for the FCC notice.
(CANADA)
When you install the NC-2010h/2100h Ethernet interface card, this printer
complies with the limits for a Class A digital apparatus, pursuant to
Canadian Interference-Causing Equipment Regulations.
(Europe)
When you install the NC-2010h/2100h Ethernet interface card, this printer
complies with EN 55022 Class A.
Warning
In a domestic environment, the printer used with an NC-2010h/2100h
Network card may cause radio interference, in which case the user
may be required to take adequate measures to prevent any such
interference.
This printer has a modular input/output (MIO) interface slot on the rear
panel. This slot allows you to install a commercial MIO-compatible
sharing/network card.
For more information about MIO cards, consult the dealer where you
purchased this printer.
To install an MIO card, follow these steps:
1. Turn off the printer and unplug the power cord from the wall socket.
Note
Be sure to turn off the power to the printer before installing or
removing the MIO card.
Be sure to remove the interface cable connector when installing the
MIO card.
CHAPTER 5 MAINTENANCE
5-41