Selecting The Optional Fonts - Brother HL-2400Ce Series User Manual

Selecting the Optional Fonts

After you have installed the optional font card, you can select optional
fonts by any of the following methods:
When you select fonts through your application software, follow the
instructions specific to your software. Refer to your software manual if
you need assistance. When you select fonts with a font selection
command, embed the font selection command in your program. See the
Technical Reference Manual, which is optionally available for this
printer.
When you select the fonts through your software or with a command,
note the following:
To select fonts with the Font button, follow these basic steps:
1. Print the list of optional fonts in the PRINT FONTS C mode with the
2. Find the font slot and font ID number on the list.
Font ID Number
1. Through your application software
2. With a font selection command
3. With the Font button
Notes
You do not need to be concerned about the Font button setting. The
software or command setting overrides the button setting.
Be sure to install the font card that has your desired fonts. The printer
automatically selects the font that has exactly the same or similar
characteristics as those you set through the software or with a
command. If the installed font card happens to have a font of similar
characteristics, the printer will print in an unexpected font.
Shift and Test buttons.
Fig. 5-47 Font ID Numbers on the Font List
CHAPTER 5 MAINTENANCE
Slot 1 or 2
5-37