Table of Contents
Advertisement
SVEX-T100 Without Wiper / SVEX-T300 With Wiper Explosion-proof Camera·Instruction Manual
No extra load on the camera, extra load may cause malfunction or damage!
DO NOT OPEN WHEN EXPLOSIVE GAS OR DUST MAYBE PRESENT!
2.2. Cable entry
There are two cable entries in the rear cover that blocked by stopping plugs in packaged
product, please replace the stopping plug with ATEX certified cable glands with sealing
compound, the Ex marking shall be Ex db IIC Gb/Ex tb IIIC Db IP68 or higher protection level.
Follow the instruction of the cable gland for correct installation.
2.3. Preparation of supports before installation
The debugging is done before package, only installation in the intended location is required.
We strongly suggest you select supports from VEILUX, it will ease your installation process
significantly.
It's the user's responsibility to ensure the support for the camera is strong enough, and the
fasteners comply with associate load and anti-rust requirements. Installation of the camera
shall ensure that it's out of reach by human beings and there is no other subject may affect the
rotation of the camera; otherwise, falling or damage may happen, even personnel safety may
be harmed.
2.3.1. Support installation
Select installation holes in proper positions, the first step is to mount the universal joint with the
base of the camera; after that adjust the fasteners of the universal joint based on the area to
be monitored to ensure the direction of the camera is correct; at last fasten the support with
anchors or plug bolts. Junction box is always installed in positions that easy for installation and
maintenance, as per Figure 2.3.1.1. The cable is connected to junction box by wire casings or
bridges.
Specification of the support see Figure 2.3.1.2, 2.3.1.3 and 2.3.1.4; universal joint see Figure
2.3.1.5.
5
Advertisement
Table of Contents
