SVEX-T100 Without Wiper / SVEX-T300 With Wiper Explosion-proof Camera·Instruction Manual
Analog system is controlled by Explosion-proof control keyboard and Explosion-proof control
box, it's available for user to monitor the scene condition.
2.5.2. Inspection and examination before power on
Check if the power and network cable are connected correctly, if the toggle switch settings are
correct before power on.
2.5.3. Service status and inspection in service
The camera will start self-checking automatically after power on.
2.5.4. Settings of camera, IE browser and client software
See camera manufacturer's instruction manual for camera, IE browser and client software
setting.
3. Trouble-shooting
Phenomenon
No image
Cannot switch to
night viewing model
Unclear image
Unstable image
Uncontrolled camera
Analysis
No power supply
Poor connection of video signal cable
Strong light in optical angle/
in manual night viewing switch model
Camera is in manual focus model/ dust
or stain on window
Poor connection of video signal cable
Bad connection of signal cable
Signal attenuation caused by long
distance
Incorrect address
Incorrect protocol
Incorrect baud rate
Incorrect model of camera
Incorrect setting of control model (SW1)
9
Solution
Check the power supply
Check the video signal
cable
Remove the strong light
Set to auto night viewing
switch model
Set to auto model/clear
the window
Check the video signal
cable
Check signal cable
connection
Use repeater to lengthen
the communication
distance
Set according to
instruction manual of
camera