Personnel; About The Operating Manual; Hazards When Handling The A-Isometer® Or Coupling Device - Bender A-ISOMETER IRDH275BU-6 Operating Manual

This operating manual, especially the safety information, must be observed
above all by personnel who work on the A-ISOMETER® or the coupling device.
In addition, the rules and regulations that apply for accident prevention at
the place of use must be observed.

1.2.1 Personnel

Only appropriately qualified staff may work on the devices. Qualified means
familiar with the installation, commissioning and operation of the product
and with training appropriate to the work.
Personnel must have read and understood the safety section and warning in-
formation in this operating manual.

1.2.2 About the operating manual

This operating manual has been compiled with the greatest possible care.
Nevertheless, errors and mistakes cannot be entirely ruled out. The BENDER
companies assume no liability whatsoever for any injury to persons or dam-
age to property which may be sustained as a result of faults or errors in this
operating manual.
1.2.3 Hazards when handling the A-ISOMETER® or coupling device
The devices are constructed according to the state-of-the-art and recognized
technical safety rules. Nevertheless, when it is being used, hazards may occur
to the life and limb of the user or third parties, or there may be adverse ef-
fects on the A-ISOMETER®s incl. coupling devices or on other valuable prop-
erty. The A-ISOMETER® incl. coupling device must only be used:
for the purpose for which it is intended
when it is in perfect technical condition as far as safety is concerned
Any faults which may impair safety must be eliminated immediately. Imper-
missible modifications and the use of spare parts and additional devices
which are not sold or recommended by the manufacturer of the devices may
cause fires, electric shocks and injuries.
Unauthorized persons must not have access to or contact with the
A-ISOMETER® incl. coupling device. Warning signs must always be easily
legible. Damaged or illegible signs must be replaced immediately.
8
Safety information
TGH1384en/06.2005