Installing The Disk Drive(S) - Lanner NCA-6520 User Manual

NCA-6520 User Manual
Installing the Disk Drive(s) (Optional)
NCA-6520 is built with two 3.5" HDD/SSD slot (HDD preferred) drive bay. The following will discuss disk
drive installation procedures based on their HDD/SSD designs.
1. Power off the system.
2. Locate the 3.5" disk bay on the front
panel.
3. To remove the tray, put your finger
on the tab and push it to the left to
slide it open, hold the tab lever and
pull out the tray.
4. The tray is designed to accommodate
one 3.5" hard disk or one 2.5" hard
disk.
Mounting a 3.5" hard disk
Secure the hard disk on the tray with
the provided disk screws. Make sure
the disk SATA connector faces
towards the SATA contacts inside the
system.
2
Disk
Screws
4
SATA Contacts
41
3