Changing Remote Retrieval Access Code; Remote Retrieval; Using Remote Retrieval Access Code - Brother FAX 4750 Operation Manual

Changing Remote Retrieval Access Code

Enter your Remote Retrieval Access Code when the machine picks up
your call, so you can access features remotely. The access code is preset
to 1 5 9 , but you can change this. The
1
For the FAX, press
For the MFC, press
2
Enter a three-digit number from 000 to 999 and press
(Do not use the same digits that appear in your Fax Receive Code or
Telephone Answer Code.)
3
Press to exit.
Stop

Remote Retrieval

You can call your machine from any fax machine using touch tone and use
a Remote Retrieval Access Code and other button presses to retrieve fax
messages. Cut out the Remote Retrieval Access Card on the last page and
keep it in your wallet as an aid.

Using Remote Retrieval Access Code

1
Dial your fax number from a fax machine using touch tone.
(See Changing Remote Retrieval Access Code on this page.)
2
When your machine answers and beeps, immediately enter your
Remote Retrieval Access Code (1 5 9
3
Your machine signals the kinds of messages received:
1 long beep — Fax message(s)
No long beeps — No messages
4
Your machine then prompts you with two short beeps to enter a command.
If you wait longer than 30 seconds to enter a command, your machine
hangs up. If you enter an invalid command, your machine beeps three
times.
5
Press to reset your machine when you're finished.
9 0
6
Hang up.
If your machine is set to Manual mode, you can access your machine by
waiting about 2 minutes, then entering the Remote Retrieval Access Code
within 30 seconds.
, , .
Function
8 3
, , , .
Function 1
8 3
R E M O T E
cannot be changed.
.
Set
).
F A X O P T I O N S 9 - 3