Email Notification; Snmp Access Control Setting; Updating Ups Snmp Device Firmware From Windows - socomec NETYS RT Installation And Operating Manual

4.5 Email Notification
This page describing of UPS email notification setting to let administrator configure Mail server and Mail receivers in order to receive
notification or report from SNMP/WEB Interface by email once power event was occurred.
1. SMTP Server Name or IP
This item is the Hostname of a SMTP Mail Server that will be used to send email messages from the SNMP/WEB Interface. If
entering a Hostname, you are also required to enter the DNS IP in the System Configuration.
2. Sender Mail Address
This item is the e-mail sender address in the following format: name@company.com.
3. Password
This item is the password of Mail Server. Default has no entry, and only required if Mail Server needed for authentication to send
mail.
4. Receiver
This column is for entering the email address of the individual you wish the SNMP/WEB Interface to send mail to.
5. Event Level
This item is for selecting the Severity level of notification you wish to send to each Mail Receiver configured to be sent Mail Type:
Events or Events/Status.

4.6 SNMP Access Control Setting

SNMP/WEB Interface supports SNMP protocol. You can use SNMP NMS to manage UPS through the network. The IP address
of the workstation must be entered in the SNMP/WEB Interface write access table to prevent unauthorized users from configuring
SNMP/WEB Interface via SN MP protocols.

4.7 Updating UPS SNMP Device Firmware from Windows

To perform firmware upgrade, use the EzSetting.exe program on the CD-ROM. This program is compatible with Windows operating
system.
1. Device List: Displays the addresses of
the UPS SNMP DEVICE present in the
local network.
2. Discover: Search for the SNMP/WEB
Interface devices in the local network.
3. Add: Lets you add the IP address of an
UPS to the Device List manually.
4. Modify: Lets you modify the parame-
ters of the device selected in the Device
List.
5. Remove: Removes the selected device
from the Device List.
6. Configuration: Provides an easy way
to do the initial configuration through
networking UDP port 3456. If you
cannot get the device information please
check and open the UDP port from your
OS.
7. Upgrade: Sends the program loaded
with the Browse button to the selected
device of the Device List.
klick to
klick to
www www
u-s-v
Y O U R C O N N E C T I O N TO S A F E T Y
ACDC-DCDC
4. MANAGING SNMP/WEB INTERFACE
4.7-1
klick to
www
Y O U R C O N N E C T I O N TO S A F E T Y
Y O U R C O N N E C T I O N TO S A F E T Y
SYSTEME
YOUR CONNECTION TO SAFETY
- Ref.: IOMNETRTXX02-GB 01
klick to klick to
www www
Y O U R C O N N E C T I O N TO S A F E T Y
CONTACT CALLBACK
15
Y O U R C O N N E C T I O N TO S A F E T Y