Brother HL-3400CN Series User Manual page 89

USER'S GUIDE
Display Message
I/F=PARALLEL
I/F=RS-232C
I/F=EXTEND I/O
I/F=AUTO
4–18
Operation Example: Selecting the Parallel Interface
To manually select the parallel interface:
Press the Sel button to take the printer off-line.
1.
Press the Mode button and then press the Set Button.
2.
When you enter the interface mode, the display first shows the
current interface with the asterisk.
3. Press the or
the display.
Note
The Extended I/O interface is available only when a commercial MIO
compatible sharing/network card has been installed.
Some models are supplied with the network card pre-installed.
Press the Set button to save your selection.
4.
An asterisk appears at the end of the display for a short time.
Then the printer automatically exits from the setting menu to
the interface menu.
5. Press the or
display.
Press the Set button.
6.
The printer then automatically returns to the off-line ready
state.
button until the interface you want appears on
Interface Mode
Parallel interface
Serial interface
Extended I/O interface
Auto interface selection
button until the exit menu appears on the