Brother HL-3400CN Series User Manual page 50

USER'S GUIDE
2–20
!
Caution
Always wait at least 5 seconds after turning off the power before turning
it on again.
Do not turn the power off while the printer is printing as this may cause a
paper jam and adversely affect the printer.
The printer performs self-diagnosis at start-up to check its hardware and
software. If the printer should find any problems, the display will change
to show the corresponding error message. See
in Chapter 6.
The display shows several messages quickly at start-up. If the printer
detects no errors, the printer initializes. This will take several minutes
during which time the LCD will display the following message:
LJ WAIT
AUTO
Once the printer has finished initializing, it automatically goes on-line
and the message changes to show the current printer status and
settings as shown below:
LJ READY 001P T1
AUTO
AUTO:
LJ:
READY:
001:
P:
T1:
:
I
NOTE: When the toner cartridges become nearly empty, the
indication blinks. The
I
color toner is empty.
"TROUBLESHOOTING"
001P T1
K C M Y
K C M Y
The auto emulation selection mode is set.
The auto emulation selection is set and
the HP PCL5C emulation is currently selected.
The printer is ready to print.
The number of copies to print is set to 1.
Portrait print is selected.
Paper is fed from Tray1.
Toner cartridges are full.
indication disappears when a
I