Brother HL-3400CN Series User Manual page 117

USER'S GUIDE
Installed memory
1 square
5 squares
15 squares
The Input buffer size increases proportionally.
4–46
INPUT BUFFER
You can increase or decrease the capacity of the input buffer with the
or button in this mode menu. A larger capacity allows the printer to
receive data from the computer faster.
Note
If the printer reports a memory full error, reduce the capacity of the input
buffer.
Display Message
:
:
memory
After you change the input buffer capacity (make sure you press the Set
button), be sure to turn off the printer and then turn it on again. The
setting takes effect when you turn the printer back on.
Notes
The set capacity is not changed even if the emulation mode is
changed.
The actual capacity of the input buffer varies according to the
installed RAM. If the RAM capacity is small, the input buffer capacity
may not be increased.
16M
30KB
0.9MB
3.0MB
Input Buffer
The more squares, the larger the capacity
of the input buffer. The squares indicate
the capacity but not the size in
Mbytes since this depends on the total
installed in the printer.
The capacity can be set to 15 levels.
(Factory setting =
32M
30KB
4.3MB
15.0MB
Fig. 4-7 Input buffer size
)
112M
30KB
21.4MB
75.0MB