Advertisement
UP
LO CK
5
1. Cut spindle and and screw to accommodate
wall side backset.
TIP: Before drilling, c
test bolt retraction; if not smooth, troubleshoot as follows:
- Check
- Ensure hole is free of debris
- Make sure 1" lock bore is perpendicular to trim bore
- Check lock by removing it from bore and throwing
the bolt. Adjust wall prep as needed
4.5)Fasten the two wood screws inside the trim
bore hole through lock body and into wood
stud.
1"
U P
LO CK
over area around the bore hole with
Ø2-1/8"
trim bore dimensions
2. Insert trim into spindle hole. Use thumb
turn to test lock bolt movement.
3. Fasten trim screws until trim is tight to
jamb surface.
NOTE: Do not over tighten.
U P
L O C
K
U P
LO CK
masking
Advertisement
