Mode Switch Settings In Br-Script 2 Mode - Brother HL-2060 User Manual

MODE Switch Settings in BR-Script 2 Mode

The following table shows all the selections you can make with the
MODE switch in the BR-Script 2 mode.
Note
The mode menus and settings that can appear vary according to the
current emulation mode, printer status, and any options that may be
installed in the printer.
Mode Menu Setting Menu
INTERFACE MODE
Same as HP LaserJet Mode
(See 4-19.)
FORMAT MODE X OFFSET=0
(See 4-22.) Y OFFSET=0
exit
RESOLUTION MODE RESOLUTION
(See 4-31.) APT SETTING
HRC SETTING
exit
CARD OPERATION When the commercial flash memory card or the HDD card has not been formatted:
(See 4-37.) CARD 1 FORMAT CARD
CARD 2
exit
exit
CARD OPERATION When the commercial flash memory card or the HDD card has been formatted:
(See 4-37.) CARD 1 EXECUTE DATA
CARD 2
CARD LIST
SAVE
DELETE
exit
Sub-Setting Menu
RESOLUTION=600
APT=OFF
HRC=MEDIUM
DATA ID=#####
SAVE DATA
SET KEY--> END
DATA ID=#####
exit
MACRO ID=#####
DATA ID=####
FONT ID=#####
FORMAT CARD
SET –> DELETE ALL
exit
CHAPTER 4 CONTROL PANEL
Setting
-500 (left) to +500 (right) dots
-500 (up) to +500 (down) dots
Exit to PAGE FORMAT MODE
300, 600 or 1200 dpi
ON or OFF
OFF, LIGHT, MEDIUM, or DARK
Exit to RESOLUTION MODE
Format the flash memory card or
the HDD card.
Exit to CARD OPERATION
CARD 1 (2)
Execute the data on the card.
Execute the selected data.
Print the contents of the card.
Send data to be saved.
End saving the data.
Set data ID for saved data.
Exit to CARD OPERATION
Delete the selected macro.
Delete the selected data.
Delete the selected font.
Format the card.
Execute formatting the card.
Exit to FORMAT CARD
OPERATION
Exit to CARD 1 (2) OPERATION
4–13