Brother HL-2060 User Manual page 134

3. Press the SET switch.
When you enter the "SELECT FONT" menu, you can select the
internal font, optional slot font, or permanent download font. The
display shows the following message.
INTERNAL FONT
Press the or switch until the desired font source appears on the
display.
Display Message
INTERNAL FONT
CARD1 FONT
CARD2 FONT
PERMANENT FONT
Since these steps instruct you to select the standard font, select the
"INTERNAL FONT" message.
Note
When you select the optional fonts or permanent download fonts, note the
following:
If the optional font card is not installed, the optional font cannot be
selected. No selection appears on the display.
If permanent fonts are not downloaded in the HP emulation mode or
another emulation mode is selected, the permanent fonts cannot be
selected. No selection appears on the display.
When you select the optional font or download font, press the SET
switch to enter the sub-menu. After you select your desired one with
the or switch, press the SET switch again. The list you can print
out with the TEST switch helps you to select the optional fonts or
permanent download fonts.
"Selecting the Optional Fonts" in Chapter 5.
4. Press the SET switch.
When you enter the font setting mode, the display first shows the
current font with an asterisk.
CHAPTER 4 CONTROL PANEL
*
Font Source
Internal font of the printer
Optional card font in slot 1
Optional font card in slot 2
Permanent download font defined
in the HP emulation mode
See "TEST switch" in this chapter or
4–59