Mode Switch Settings In Hp-Gl Mode - Brother HL-2060 User Manual

MODE Switch Settings in HP-GL Mode

The following table shows all the selections you can make with the
MODE switch in the HP-GL mode.
Note
The mode menus and settings that can appear vary according to the
current emulation mode, printer status, and any options that may be
installed in the printer.
Mode Menu Setting Menu
INTERFACE MODE
Same as LaserJet Mode
(See 4-19.)
FORMAT MODE PAGE FORMAT MODE
(See 4-22.)
GRAPHICS MODE
exit
RESOLUTION MODE RESOLUTION
(See 4-31.) HRC SETTING
exit
Sub-Setting Menu
PAPER=LETTER
(For 110/120V mode)
X OFFSET= 0
Y OFFSET= 0
exit
PEN SETTING
SETTING PEN1
SIZE #=3 dots
GRAY #=100%
exit
exit
CHARACTER SET
STANDARD SET
ANSI ASCII
ALTERNATE SET
ANSI ASCII
exit
RESOLUTION=600
HRC=MEDIUM
CHAPTER 4 CONTROL PANEL
Setting
LETTER, LEGAL, A4, A5,
A6, B5, B6, EXECUTIVE,
COM10, MONARCH, C5,
and DL
-500 (left) to +500 (right) dots
-500 (up) to +500 (down)
dots
Exit to PAGE FORMAT
MODE
PEN1 to 6
(Set size and gray
percentage for the selected
pen. )
1 to 10 dots (pen size in
dots)
(# is the selected pen
number. )
15, 30, 45, 75, 90, or 100%
(# is the selected pen
number. )
Exit to SETTING PEN1–6
Exit to GRAPHICS MODE
Standard character set
See character sets on page
4-28.
Alternate character set
See character sets on page
4-28.
Exit to GRAPHICS MODE
Exit to FORMAT MODE
300, 600 or 1200 dpi
OFF, LIGHT, MEDIUM, or
DARK
Exit to RESOLUTION MODE
4–15