Brother HL-2060 User Manual page 96

Serial Interface
When you intend to use the serial interface, be sure to select the same
communications parameters on both the printer and computer. You must
set them for the automatic interface selection, too.
Display Message
BaudRate= 9600
CodeType=8 bits
Parity =NONE
Stop Bit=1 bits
Xon/Xoff=ON
DTR(ER) =ON
(Effective when
Xon/Xoff=ON)
Robust Xon =OFF
(Effective when
Xon/Xoff=ON)
Universal Serial Bus (USB) interface
If your computer has a USB interface, you can connect the printer and
computer with the USB interface. When using the USB interface, select
the interface on the display as follows;
Parameters
Baud rate
(Data transfer speed)
Code type
(Data length)
Parity
(Data error check)
Stop bits
(Data separator)
Xon/Xoff
(Handshake protocol)
Data terminal ready
(ER)
Robust Xon
I/F=USB
CHAPTER 4 CONTROL PANEL
Settings
150, 300, 600, 1200, 2400, 4800,
9600, 19200, 38400, 57600, 115200
baud
7 bits or 8 bits
None, even, or odd
1 or 2
ON: DTR & Xon/Xoff handshake
OFF: DTR handshake only
ON: Makes DTR (ER) low when
the buffer is full.
OFF: Does not make DTR (ER)
low when the buffer is full.
DTR(ER) goes low only
when the printer is off-line.
ON: Sends Xon while waiting.
OFF: Sends Xon once, when the
printer status changes from
off-line to on-line.
4–21