Setting The Ring Volume; Setting The Beeper Volume; Setting The Speaker Volume; Memory Storage - Brother MFC-6800 Owner's Manual

Setting the Ring Volume

1
Press Menu/Set, 1, 4, 1.
2
Press to select (OFF, LOW,
or
or HIGH), and then press Menu/Set.
3
Press Stop/Exit.
—OR—
You can adjust the ring volume when your MFC is idle. You can turn the ring
OFF or you can select a ring volume level.
Press or to adjust the volume level. With each key press, the MFC rings so
you can hear the active setting as the LCD shows it.
Each key press changes the volume. The new setting will remain until you
change it again.

Setting the Beeper Volume

You can set the beeper to LOW,
When the beeper is set to
a key or make an error and when fax sending or receiving has finished.
1
Press Menu/Set, 1, 4, 2.
2
Press to select your option.
or
3
When the LCD shows the option you want, press Menu/Set.
4
Press Stop/Exit.

Setting the Speaker Volume

You can turn off the volume of the MFC one-way speaker.
1
Press Menu/Set, 1, 4, 3.
2
Press to select
or
3
Press Stop/Exit.

Memory Storage

In the event of a power failure, all settings in the
RECEIVE, SET AUTO
SETUP and COVERPAGE MSG
permanently. You may have to reset the date and time.
4 - 4
I N I T I A L S E T U P
MED
HIGH
LOW or HIGH, the MFC beeps every time you press
ON (or OFF), and then press Menu/Set.
DIAL, REMOTE FAX
functions (from
or OFF. The default setting is LOW.
GENERAL
OPT, plus the
SETUP
SETUP, SETUP
COVERPG
SEND) are stored