Table of Contents
Advertisement
DIFFICULTY
The MFC does not print. Check the following:
The MFC prints
unexpectedly or it prints
garbage.
The MFC cannot print
full pages of a
document; the error
message PRINT
OVERRUN occurs.
The MFC prints the
first couple of pages
correctly, then some
pages have text missing.
The MFC cannot print
full pages of a
document; A
MEMORY FULL error
message occurs.
My headers or footers
appear when I view my
document on the screen,
but do not appear when I
print them.
T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E
SUGGESTIONS
General Printing Difficulties
• The MFC is plugged in.
• The toner cartridge and drum unit are installed
properly.
• The interface cable is securely connected
between the MFC and computer.
• Check to see if LCD is showing an error message.
(See pages 15-2 to 15-5)
Reset the MFC . Check the primary settings in your
application software to make sure it is set up to
work with your MFC.
The MFC received a very complex print job and
could not process part of the page. This may be
solved in several ways. If you are using Windows
3.1x, Windows
Workstation Version 4.0 with the supplied printer
driver, see the "Windows
Problems" section. Try to reduce the complexity of
your document or reduce print resolution.
Your computer is not recognizing the printer input
buffer's full signal. Please make sure to connect the
printer cable correctly.
Reduce the printer resolution. Reduce the
complexity of your document and try again.
Reduce the graphic quality or the number of font
sizes within your application software.
Most laser printers have a restricted area that will
not accept print. Usually these are the first two
lines and last two lines, leaves 62 printable lines.
Adjust the top and bottom margins in your
document to allow for this.
®
95/98/98SE or Windows NT
®
Setup Printing
®
®
15 - 11
Advertisement
Table of Contents
