Washing; Before Getting Started; Starting The Cycle; Suspending And Continuing The Cycle - Hanseatic HWM5T110D User Manual

Washing

Before getting started

• Read the "Safety" chapter from
page EN-4, in particular the safety notic-
es.
• Remove the transport safety devices
and prepare the appliance as described
in chapter "Set up and connection" on
page EN-27.
• Properly attach the water inlet hose (25)
and the water outlet hose (13).

Starting the cycle

(2) (3)
Aus
Extrakurz 15' Baumwolle
Anzeige
Kurz 60' Eco 40-60
Jeans/
Baumwolle
Dunkle Kleidung
Mix Baumwolle
20°C
Sport /
Buntwäsche
Pflegeleicht
Hand-/
Wolle
Feinwäsche
Schleudern/Abpumpen / / Spülen
Allergie
1. Select the desired wash cycle using the
cycle selector (2).
2. Make changes if necessary: To adjust the
• temperature, press the "Temp." but-
ton (4) repeatedly until the desired val-
ue is shown in the display (3).
• To change the spin speed, press
the "Spin" button (5) repeatedly until
the desired value is shown in the dis-
play (3).
3. Open the valve completely.
4. Press the "Start/Pause" button (7).
The cycle starts.
The cycle LED (8) stays on.
The remaining cycle time is shown in the
display (3).
The door is locked.
(4) (6) (7)
(5)
Fu Funktionen u u e n n
Startzeit-
Temp. Schleudern vorwahl
Start /
Pause
(8)
Washing
Suspending and continuing
the cycle
Please note that a long pause can affect the
wash result, as the soapy water cools down.
• If you want to stop the cycle, for example
to put in additional washing, press the
"Start/Pause" button (7) .
The cycle LED (8) will flash during the in-
terruption.
Depending on the cycle's progress, the
door will either be released or remain
locked.
• Press the "Start/Pause" button (7) again
to continue the cycle.

Suspending/altering the cycle

1. Turn the cycle selector (2) to "Off" to can-
cel an active cycle or to select an alterna-
tive cycle.
This will stop the cycle.
2. Use the cycle selector (2) to select any
cycle.
The soapy water will now be drained.
3. Use the cycle selector (2) to select a new
cycle and add detergent if required.
4. Start the new cycle with the "Start/Pause"
button (7).

Cycle end

The appliance stops automatically as soon as
the selected cycle is finished. "End" will now
be shown in the (3) display.
1. Turn the cycle selector (2) to "Off".
2. Once the locking time has completed af-
ter approx. 2 minutes and you hear a click
releasing the door, you can then remove
the laundry.
3. Leave the loading door open between
wash cycles and pull the dispensing
drawer (1) out slightly to allow the inside
of the appliance to dry.
4. Turn off the tap and take the mains plug
out of the wall socket.
Page EN-17