Setting Volume Amplify; Setting The Speaker Volume; Setting The Ring Volume; Memory Storage - Brother FAX 560 Owner's Manual

Setting Volume Amplify

Please carefully read "Setting the Handset Volume" before you do the following steps:
1
Press Function/Set, 1, 4.
2
Press or
AMPLIFY:OFF? if none of the users are
hearing-impaired and go to Step 4—OR—If
some or all of the users are hearing-impaired,
select VOL AMPLIFY:ON?
3
Press or
all the users are hearing-impaired—OR—
Select TEMPORARY? if only some of the
users are hearing-impaired..
4
Press Function/Set.
5
Press Stop to exit.

Setting the Speaker Volume

You can adjust the speaker volume when your fax machine is onhook (after you
pressed Hook), by selecting a speaker volume level.
Press or
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.

Setting the Ring Volume

You can adjust the ring volume when your fax machine is idle. You can select a ring
volume level or press until the ring is off.
Press or
rings so you can hear the current setting and the display shows the setting you are
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.

Memory Storage

In the event of a power failure, all settings in the INITIAL SETUP, SETUP RECEIVE,
SET AUTO DIAL and REMOTE FAX OPT plus the COVERPG SETUP and
COVERPAGE MSG (from SETUP SEND) functions are stored permanently. You
may have to reset the date and time.
4 - 5
I N I T I A L S E T U P
to select VOL
to select PERMANENT? if
to adjust the volume level. The display shows the setting you are
to adjust the volume level. With each key press, the fax machine
VOL AMPLIFY:OFF?
SELECT < - - > & SET
PERMANENT?
SELECT < - - > & SET