Commissioning; Function Check; Switching On The Measuring Device - Endress+Hauser Profi Bus Levelflex M FMP40 Operating Instructions Manual

Commissioning

⇒
ENDRESS + HAUSER
– +
E
62
6 Commissioning
6.1

Function check

Make sure that all final checks have been completed before you start up your measuring point:
• Checklist "Post-installation check", → ä 33.
• Checklist "Post-connection check", → ä 38.
6.2

Switching on the measuring device

When the device is switched on for the first time, the following messages appear in a sequence of 5
s on the display: software version, communication protocoll and language selection
⇓
⇓
⇓
Levelflex M FMP40 PROFIBUS PA
Select the language (this message appears the first time
the device is switched on)
Select the basic unit (this message appears the first time
the device is switched on)
The current measured value is displayed
F
After is pressed, you reach the group selection
This selection enables you to perform the basic setup
Endress+Hauser