Return; Disposal - Endress+Hauser Profi Bus Levelflex M FMP40 Operating Instructions Manual

Trouble-shooting
98
9.5

Return

The following procedures must be carried out before a transmitter is sent to Endress+Hauser e.g.
for repair or calibration:
• Remove all residue which may be present. Pay special attention to the gasket grooves and crevices
where fluid may be present. This is especially important if the fluid is dangerous to health, e.g.
corrosive, poisonous, carcinogenic, radioactive, etc.
• Always enclose a duly completed "Declaration of contamination" form (a copy of the "Declaration
of contamination" is included at the end of this operating manual).
Only then can Endress +Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EN 91/155/EEC.
Additionally specify:
• An exact description of the application
• The chemical and physical characteristics of the product
• A short description of the error that occurred (specify error code if possible)
• If necessary, give the error code
9.6

Disposal

In case of disposal please seperate the different components according to their material consistence.
Levelflex M FMP40 PROFIBUS PA
Endress+Hauser