Tips To Maximize Your Generator's Performance; Pro Multi-Gen 7 And Multi-Gen 7Xl Introduction; Description; Attachment Of The Adapter To The Drive Motor: (See Figure 3 & 4) - PRO Scientific Bio-Gen PRO200 Operating Manual

Tips to maximize your generator's performance.

1. Never run the generator assembly dry. The generator requires a liquid sample/medium to lubricate the bearings
during processing.
2. Without the liquid, the bearings can burn out and cause damage to the generator itself.
3. Make sure you are processing the recommended sample volume for the generator/generator assembly you are
using. If you are unsure if this is the correct generator for your application, please contact a sales representative
before using the generator.
4. Always begin homogenizing at a low rpm, and then gradually increase the speed to your target level.
5. Please follow the instructions in the manual to ensure that you attach the generator/generator assembly
properly to the motor unit.
6. We recommend taking apart and cleaning generators on a regular basis.

PRO MULTI-GEN 7 and MULTI-GEN 7XL Introduction

Description:

consists of a generator tube, rotor shaft and knife assembly, drive collar and a set of PTFE bearings. MULTI-
GEN generators require the use of the Multi-Gen Generator adapter attached to a motor unit in
order to operate.
Attachment of the Adapter to the Drive Motor: (see figure 3 & 4)
1) Align the grooves in the side of the adapter's upper collar with the two (2) pins at the bottom of the
motor collar.
2) Push the adapter into the motor collar.
3) Once inserted as far as it will go, turn the adapter left until you feel the adapter lock into place. This should be
approximately ¼ turn. The collar is spring loaded so you will feel some light resistance as you push the generator
inward and turn.
4) Once the adapter is attached to the motor collar, it is important that the safety clip supplied with the adapter be
inserted between the bottom of the motor collar and the shoulder of the
adapter. Proper insertion of the safety clip will prevent the adapter from
disengaging from the motor collar when ejecting the used generator.
22
Figure 3
Figure 4