General Safety Information; Read Safety Instructions - TDK-Lambda Genesys GENH Series User Manual

GENERAL SAFETY INFORMATION

READ SAFETY INSTRUCTIONS

The following safety precautions must be observed during all phases of operation, service and repair of this
equipment. Failure to comply with the safety precautions or warnings presented in this document violates
safety standards of design, manufacture and intended use of this equipment and may impair the built-in
protections within. TDK-Lambda shall not be liable for user's failure to comply with these requirements.
SERVICING
These products are not customer serviceable. Parts substitutions and modifications are by authorized
TDK-Lambda service personnel only. For repairs or modifications, the product must be returned to TDK-
Lambda service facility.
CRITICAL COMPONENTS
These products are not authorized for use as critical components in nuclear control systems, life support
systems or equipment for use in hazardous environments without the express written approval of the
Managing Director of TDK-Lambda Ltd.
PRODUCT USAGE
These products are designed for use as standalone equipment within the limits described in the user
manual. They are not designed for general home or consumer use, and are designed for indoor use.
ENVIRONMENTAL
These products are IP20, and therefore chemicals/solvents, cleaning agents and other liquids must not
be used.
ENVIRONMENT
These products are designed for use within a Pollution Degree 2, Overvoltage Category II environment,
and must be operated within the environmental conditions (temperature, altitude, etc.) specified in the
user manual.
OUTPUT LOADING
The output power taken from the product must not exceed the rating stated on the product label, except as
stated in the user manual. The insulation of the wire connected to the DC output should be in accordance
with the output load current and voltage.
INPUT PARAMETERS
These products must be operated within the input parameters stated in the user manual. The means of
connecting this equipment to the supply must only be according to the instructions specified in the user
manual to reduce risk of hazard. Connection to AC MAINS must be done by an electrical or other
qualified personnel.
END OF LIFE DISPOSAL
The product contains components that require special disposal. Make sure that the unit is properly disposed
of at the end of its service life and in accordance with local regulations.
EQUIPMENT OPERATION AND OPERATING CONTROLS
Identification and description of operating controls and their use in all operating modes are stated in the
user manual. Operating of the equipment is explained in detail in the user manual.
VENTILATION
The ventilation openings on these products must not be covered. Ensure that there is at least 10cm spacing
between any obstruction and the ventilation openings.
IA598-04-01U