ADJUSTMENTS AND REPLACEMENTS
Section 1: Service Overview
Special Tools
Tool No.
TL-2431
AIR METER
TL-1434
Carpenter's LEVEL, approximately 30
cm (12 in.) long
TL-2170
CLAMPS (Order 2)
7C8444
DIAGNOSTICS DISKETTE
TL-4430
EXTRACTION TOOL
TL-3346
GROUNDING KIT
TL-4391
INTERFACE CABLE
TL-2324
LITHIUM BALL and ROLLER BEARING
GREASE
TL-1926
MAGNETIC POWER WARNING SIGN
------
PORTABLE COMPUTER1
1C8022
SEALANT
TL-2192
THERMAL GREASE
7C8515
DOWNLOAD DISKETTE
Electrostatic Discharge
Overview
ESD--electrostatic discharge--is a primary source of:
• product downtime
• lost productivity
• costly repairs
While one cannot feel a static charge of less than 3,500 volts, as few as 30 volts can damage or destroy
essential components in electronic equipment.
Preventive Measures
• Always look for an ESD warning label before doing any procedure involving static-sensitive
components such as CIRCUIT BOARDS. All static-sensitive components are marked with bright
graphic labels, which frequently include instructions. Follow all label instructions.
• Wear a GROUNDING STRAP when handling static-sensitive components. Always make certain
that the CLIP remains attached to a properly grounded, unpainted, clean surface.
• Repair static-sensitive components at an ESD-protected work station or use a PORTABLE
GROUNDING MAT. For help in setting up an ESD-protected work station, contact your Kodak
representative.
• When moving static-sensitive components from one area to another, insert and transport the
components in ESD-protective packaging.
4
Description
1. Requirements for the PORTABLE COMPUTER:
• be an IBM compatible computer
• have MS-DOS version 3.0 or higher installed on the
HARD DISK
⁄
1
• have a 720 KB 3
in. DISK DRIVE
2
• have a serial communications port configured as
COM 1: See the User Manual for the PORTABLE
COMPUTER.
28JAN98 – 7C8285