Powering and Connecting the GSC3620
The GSC3620 can be powered either using the right PSU (DC12V, 1A) or using a PoE switch, please refer
to illustration below to do the wiring and connect the waterproof RJ45 socket:
Option A (Recommended)
1. Based on T-568B (see diagram below) to install the RJ45 plug, tighten the connector using the
provided waterproof socket.
2. Connect other end of the cable into a switch supporting Power over Ethernet.
Option B
1. Wire the cable and connect it to a network switch as in the figure above.
2.
Connect a 12VDC, 1A (minimum) Power Adapter (not provided) to the power socket of the
GSC3620 tail cable. Make sure the polarity "+" (center) and "-" (outside) are correctly connected.
Figure 2: RJ45 plug installation
GSC3620 Series User Manual
Version 1.0.5.3
P a g e
|
15